Shimpo DFS-series Instrukcja Użytkownika

Congratulations on your purchase of a Shimpo DFS (DigitalForce Gauge). We trust you will enjoy many years ofprofessional results from your DFS for fo

10Communication With External Devices (continued)RS232Depending upon the type of data collection device that is being used with the DFS, it may be nec

11External Control CommandsThe chart below lists the ASCII Capital Characters andtheir functions for controlling the DFS from a computeror other exter

12Communication With External Devices (continued)External Control Command Descriptions (continued)! APF ____________________ Auto-Power-OffAPF # CR

13Communication With External Devices (continued)DigimaticDigimatic output is used for Mitutoyo data collectors and printers (refer to RS232 memory da

14Communication With External Devices (continued)External Control InputNOTE: To activate the comparator cable, either “RS232” or “nonE” needs to be se

15Communication With External Devices (continued)External TareTo tare, short pins 5 and 10 for at least 25mS.External HoldChoose edge or level trigger

16Communication With External Devices (continued)Overload OutputThe DFS possesses an overload output feature (DFS-CTRLCABLE) to protect the load cell

17Parameter SettingsThe DFS will default to certain parameters when power is turned OFF and ON. To access the parameter settings:1. Press the PEAK bu

18Low Battery IndicationThe batteries should be changed when “LO BAT” appears on the display.NOTE: Parameters and data in memory can be saved if the A

19TroubleshootingThe following are general checkpoints; please call your local Shimpo representative or contact Shimpo Instruments directly forfurther

2Important Safety InstructionsInspection/Standard AccessoriesIf any damage is apparent, do not unpack the DFS. Notifythe shipping carrier immediately

20WarrantyLIMITED EXPRESS WARRANTY: Shimpo Instruments warrants, to the original purchaser of new products only, that this product shall be free from

3Set-UpPowerEvery DFS unit is shipped from the factory without the batteries (provided) installed. To install the batteries:1. Remove the battery pla

4Display & Keypad 1. Sensor Shaft 2. Low Battery Indicator 3. Peak Indicator (NOTE: Refer to “Changing the Measuring Mode” section for explanat

5Factory SettingsEach time the power is turned OFF and ON there are some parameters that the DFS will default to. Consult the sectionon “Parameter Se

64. Press MEMO SET button to store the measuring mode and exit.NOTE: By keeping the true peak mode “ON”, the DFS will always display the peak samples

7Operation (continued)Changing Display Update TimeThe display update time works with the sampling rate (1000 hz) to provide an average reading. All s

8Operation (continued)Deleting Data (Single and Continuous Memory Mode)While recalling data (see above) it is possible to delete one data reading at a

9Communication with External DevicesWhen operated with the proper cable, the DFS offers a variety of output and input abilities for bi-directional com